ECU Chip Tuning Valeo V40

Valeo V40 — Valeo control unit. On this unit the following is available: Stage 1 for power, removal from the logic of the EGR system · the catalytic converter/lambda · EVAP, disabling the swirl flaps, Pops & Bangs, Speed Limit Off, DTC Off, rollback to the factory calibration and Cold Start Off. In the database — 3 modifications on Renault and Dacia. Read/write: Autotuner, MPPS, MagicMotorSport, KT200, FoxFlash.

3 engines in database 2 brands 11 options

Supported Options

CHECK STOCK OR NOT

CHECK STOCK OR NOT

CHECK STOCK OR NOT — проверка файла на наличие заводской (оригинальной) прошивки или внесённых изменений.

Learn more about the service
STAGE 1

STAGE 1

Stage 1 — это программный тюнинг двигателя без установки механических деталей. Он улучшает работу двигателя, повышает мощность и крутящий момент, сохраняя надежность и безопасность.

Learn more about the service
DTC OFF

DTC OFF

DTC Off — это программное отключение кодов ошибок, при котором выбранные ошибки больше не отображаются и не вызывают аварийный режим.

Learn more about the service
VMAX OFF

VMAX OFF

VMAX Off — это программное отключение ограничителя максимальной скорости, позволяющее автомобилю развивать скорость без заводских ограничений.

Learn more about the service
EVAP OFF

EVAP OFF

EVAP Off — это программное отключение системы улавливания паров топлива, которое устраняет ошибки и проблемы, связанные с работой этой системы.

Learn more about the service
COLD START OFF

COLD START OFF

Cold Start Off — это программное отключение холодного запуска, которое убирает повышенные обороты и громкую работу двигателя при запуске, делая запуск более мягким и комфортным.

Learn more about the service
FLAPS OFF

FLAPS OFF

Flaps Off — это программное отключение впускных заслонок, которое предотвращает их заклинивание, улучшает надежность двигателя и устраняет связанные с ними ошибки.

Learn more about the service
POP AND BANGS

POP AND BANGS

Pop and Bangs — это программная функция, создающая хлопки и треск в выхлопной системе при сбросе газа, делая звук автомобиля более спортивным.

Learn more about the service
CAT/LAMBDA OFF

CAT/LAMBDA OFF

CAT/Lambda Off — это программное отключение катализатора и лямбда-зондов, которое устраняет ошибки, предупреждения и ограничения, связанные с системой выхлопа.

Learn more about the service
EGR OFF

EGR OFF

EGR Off — это программное отключение системы EGR, которое уменьшает нагар во впуске, улучшает работу двигателя и устраняет связанные с системой ошибки.

Learn more about the service
RESET TO STOCK

RESET TO STOCK

Reset to Stock — это возврат программного обеспечения блока управления двигателем в оригинальное заводское состояние.

Learn more about the service

Brands with ECU Valeo V40

Frequently asked questions

Where is the Valeo V40 ECU used?

The Valeo V40 ECU is fitted to 3 engines in the CHIPOK database across 2 brands. Top: Renault (2), Dacia (1).

What can be flashed on the Valeo V40 unit?

The Valeo V40 ECU supports: CHECK STOCK OR NOT, STAGE 1, DTC OFF, VMAX OFF, EVAP OFF, COLD START OFF, FLAPS OFF, POP AND BANGS, CAT/LAMBDA OFF, EGR OFF. Checksums are recalculated on the engineer's side in WinOLS5.

Which programmers read the Valeo V40 ECU?

The Valeo V40 is supported by: KESS3, Autotuner, MPPS, KTAG, CMD Flash, Trasdata, MagicMotorSport. On production models OBD reading is usually enough; on locked variants — Bench (BDM/JTAG).

What changes in the Valeo V40 with Stage 1?

Stage 1 on the petrol Valeo V40 reprograms ignition timing, lambda target, boost target and wastegate duty (on turbo), throttle response, VANOS/VVT phase, torque limiter.

In what format is a Valeo V40 file accepted at CHIPOK?

A Valeo V40 file is accepted in .bin/.hex/.ori format (full read) from any programmer: Autotuner, KESS3 (OBD), KTAG (bench), Trasdata. Checksums are recalculated by hand in WinOLS5.

How quickly is a Valeo V40 file processed?

Flashing the Valeo V40 takes 25-30 minutes in OBD mode or ~60 minutes on Bench. Once the file is received, CHIPOK processes it in 5-30 minutes.

How much does a file for the Valeo V40 cost?

The cost of flashing the Valeo V40 is calculated in the price calculator: you select options (Stage 1/2, DPF off, EGR off, AdBlue off, DTC off, etc.) and the final price is capped by the package Max Price. Paid with credits (1 cr = 1 €), no subscriptions.