ECU Chip Tuning Bosch EDC15C9

Bosch EDC15C9: early-2000s Bosch diesel ECU (Pumpe-Düse, early Common Rail) on a C167 core. Stage 1 for power, removal from the logic of the diesel particulate filter (DPF) · the EGR system, disabling the swirl flaps, hard rev cut and DTC Off, rollback to the factory calibration — Autotuner, KESS3 (OBD), KTAG (bench), Trasdata. In the database — one modification only on Toyota.

1 engine in database 1 brand 9 options

Supported Options

STAGE 1

STAGE 1

Stage 1 — это программный тюнинг двигателя без установки механических деталей. Он улучшает работу двигателя, повышает мощность и крутящий момент, сохраняя надежность и безопасность.

Learn more about the service
HARD CUT LIMIT

HARD CUT LIMIT

Hard Cut Limit — это программная настройка жесткого ограничителя оборотов, при которой подача топлива или зажигание резко отключается на максимальных оборотах, создавая более агрессивную работу двигателя.

Learn more about the service
DPF OFF

DPF OFF

DPF Off — это программное отключение сажевого фильтра, которое устраняет ошибки, аварийный режим и частые регенерации, улучшая стабильность работы двигателя.

Learn more about the service
DTC OFF

DTC OFF

DTC Off — это программное отключение кодов ошибок, при котором выбранные ошибки больше не отображаются и не вызывают аварийный режим.

Learn more about the service
FLAPS OFF

FLAPS OFF

Flaps Off — это программное отключение впускных заслонок, которое предотвращает их заклинивание, улучшает надежность двигателя и устраняет связанные с ними ошибки.

Learn more about the service
TVA OFF

TVA OFF

TVA Off — это программное отключение системы TVA (заслонки во впуске / управление воздушным потоком), которое устраняет ошибки, улучшает стабильность работы двигателя и повышает надежность системы впуска.

Learn more about the service
CHECK IF STOCK OR NOT

CHECK IF STOCK OR NOT

CHECK IF STOCK OR NOT — проверка файла на наличие заводской (оригинальной) прошивки или внесённых изменений.

Learn more about the service
EGR OFF

EGR OFF

EGR Off — это программное отключение системы EGR, которое уменьшает нагар во впуске, улучшает работу двигателя и устраняет связанные с системой ошибки.

Learn more about the service
RESET TO STOCK

RESET TO STOCK

Reset to Stock — это возврат программного обеспечения блока управления двигателем в оригинальное заводское состояние.

Learn more about the service

Brands with ECU Bosch EDC15C9

Frequently asked questions

Where is the Bosch EDC15C9 ECU used?

The Bosch EDC15C9 ECU is fitted to 1 engine in the CHIPOK database across 1 brand. Top: Toyota (1).

What can be flashed on the Bosch EDC15C9 unit?

The Bosch EDC15C9 ECU supports: STAGE 1, HARD CUT LIMIT, DPF OFF, DTC OFF, FLAPS OFF, TVA OFF, CHECK IF STOCK OR NOT, EGR OFF, RESET TO STOCK. Checksums are recalculated on the engineer's side in WinOLS5.

Which programmers read the Bosch EDC15C9 ECU?

The Bosch EDC15C9 is supported by: KESS3, Autotuner, MPPS, KTAG. On production models OBD reading is usually enough; on locked variants — Bench (BDM/JTAG).

What changes in the Bosch EDC15C9 with Stage 1?

Stage 1 on the diesel Bosch EDC15C9 reprograms rail pressure target, SOI/EOI timing, boost target, smoke limiter and torque limiter. The torque gain is noticeable; the HP gain depends on the specific engine.

In what format is a Bosch EDC15C9 file accepted at CHIPOK?

A Bosch EDC15C9 file is accepted in .bin/.hex/.ori format (full read) from any programmer: Autotuner, MPPS, MagicMotorSport, KT200, FoxFlash. Checksums are recalculated by hand in WinOLS5.

How quickly is a Bosch EDC15C9 file processed?

Flashing the Bosch EDC15C9 takes 25-30 minutes in OBD mode or ~60 minutes on Bench. Once the file is received, CHIPOK processes it in 5-30 minutes.

How much does a file for the Bosch EDC15C9 cost?

The cost of flashing the Bosch EDC15C9 is calculated in the price calculator: you select options (Stage 1/2, DPF off, EGR off, AdBlue off, DTC off, etc.) and the final price is capped by the package Max Price. Paid with credits (1 cr = 1 €), no subscriptions.