Online service · 24 / 7

Bosch EDC17U05 Clone: VAG (Seat · Skoda · Volkswagen)

Clone on the Bosch EDC17U05 control unit for vehicles of the VAG group: Seat, Skoda, Volkswagen. Upload the dump — free analysis and check; apply the operation and download the ready file in your portal account.

Bosch EDC17U05 Clone online
Bosch EDC17U05 · Clone
Supported

Transfer of immo data from one ECU dump to another — the donor unit starts responding to the keys and BCM/CAS of the recipient vehicle.

OperationClone
Control unitBosch EDC17U05
Car makesVAG — Seat, Skoda, Volkswagen
Access / memoryINT FLASH [TC1796] · INT EEPROM [TC1796]
INT FLASHTC1796
INT EEPROMTC1796
MethodOnline, from the ECU memory dump (.bin)
Applicability checkFree
ChecksumsRecalculated automatically
ResultA ready file to write to the unit
Continue in the portal50 € Uploading and analyzing the file — free. Applying «Clone» and downloading the ready file — in your portal account.

Bosch EDC17U05 Clone — 6 vehicles

Operation Clone is supported for the Bosch EDC17U05 block on vehicles of the VAG group (Seat, Skoda, Volkswagen). In the list: Skoda Fabia, Seat Cordoba, Volkswagen Polo, Skoda Praktik, Seat Ibiza, Skoda Roomster. Upload the dump — the system detects the version and checks applicability for free.

SeatSkodaVolkswagen
MakeModelVersionPowerFuelYear
Skoda Fabia 1.4 TDI 5MT 59 kW Diesel 2008
Seat Cordoba 1.4 TDI 5MT 59 kW Diesel 2008
Volkswagen Polo 1.4 TDI 5MT 59 kW Diesel 2009
Skoda Praktik 1.4 TDI 5MT 59 kW Diesel 2008
Seat Ibiza 1.4 TDI 5MT 59 kW Diesel 2008
Skoda Roomster 1.4 TDI 5MT 59 kW Diesel 2008

Bosch EDC17U05 Clone — for VAG (Seat, Skoda, Volkswagen)

Cloning transfers the immobiliser data and identifiers from the original control unit into a donor one. After the operation the donor answers to the factory keys, BCM and CAS of the receiving car, and no dealer coding is required.

When you need Clone

  • Board beyond repair — the board is flooded, burnt or mechanically damaged — the data moves into a donor.
  • ECU reads but will not start — the contents are intact while the unit is faulty — the donor receives the same immobiliser data.
  • Used donor unit — a unit from another car is tied to a foreign key and BCM.
  • No access to dealer coding — the clone starts without a visit to an official dealer.

What you get: the donor unit works like the original — the keys, BCM and CAS of the car accept it without coding.

Bosch EDC17U05 memory and reading

The Bosch EDC17U05 unit uses the following: INT FLASH — TC1796, INT EEPROM — TC1796. The Clone operation works on the INT FLASH [TC1796] · INT EEPROM [TC1796] area — that is the one to read out and upload. If OBD reading is not available for this unit, the dump is taken on the bench via Bench or Boot mode.

For the Bosch EDC17U05 block the «Clone» operation runs online from the ECU memory dump (access — INT FLASH [TC1796] · INT EEPROM [TC1796]). Read the file via OBD, Bench or Boot and upload it — the system detects Bosch EDC17U05 and checks whether the operation applies for free. You'll get the ready file with recalculated checksums in your portal account.

Frequently asked questions

Clone on Bosch EDC17U05 — short and to the point

What does Clone do on Bosch EDC17U05?

+

Transfer of immo data from one ECU dump to another — the donor unit starts responding to the keys and BCM/CAS of the recipient vehicle.

Which file should I upload?

+

The ECU memory dump (access INT FLASH [TC1796] · INT EEPROM [TC1796]), read via OBD, Bench or Boot. Upload the file — the system detects Bosch EDC17U05 for free and checks whether the operation applies.

How much does Clone cost?

+

Uploading and analyzing the file is free. Applying the operation and downloading the ready file happen in your portal account (50 €).

Are the checksums recalculated?

+

Yes, automatically. The ready file is immediately writable to the unit — no need to recalculate checksums by hand.

Which vehicles is it for?

+

Bosch EDC17U05 with the Clone operation covers VAG group vehicles (Seat, Skoda, Volkswagen). The system detects the exact version from the uploaded dump.

What memory and processor does Bosch EDC17U05 use?

+

Memory of the unit: INT FLASH — TC1796, INT EEPROM — TC1796. The Clone operation needs INT FLASH [TC1796] · INT EEPROM [TC1796] access.