Volvo Penta — Stage 1 / Stage 2 parameters database
The CHIPOK database holds 17 engines for Volvo Penta with reverse-engineered ECUs and Stage 1 / Stage 2 target parameters. We cover 17 models — from early generations to current platforms. Diesel engines only.
Models17
Engines17
ECU makersBosch / Continental / Denso / Siemens
File turnaround30–60 min
or choose step by step
1
Choose a vehicle type
2
Choose a make
3
Choose a model
4
Generation / years
5
Engine
Volvo Penta models in the database (17)
About Volvo Penta chip tuning
Engines and platforms:
- Main engines: D2 (75 hp), D3 (110-220 hp), D4 (180-320 hp), D6 (310-480 hp), D8 (500-625 hp), D9 (425-575 hp), D11 (510-625 hp), D13 (700-1000 hp), D16 (650-1000 hp), IPS400/450/500/600/650/800/950/1050/1200/1350, V6/V8 sterndrive (gas)
- Platforms: Marine inboard, Sterndrive (DP/DPS/DPH), IPS-pod, Aquamatic
Supported ECUs:
- Manufacturers: Bosch / Continental / Denso / Siemens
- Specific Volvo Penta units in the database: Bosch EDC7UC31 (legacy D6/D9/D12/D16), EDC17CV41, EDC17CV44, EDC17CV45 (new D6/D8/D13), Volvo Penta MD-block, EVC-A (Electronic Vessel Control gen1), EVC-B, EVC-C, EVC-D, EVC-EC, EVC-E, EMS2.X, EMS3.X (based on Volvo Trucks), Helm Master / Glass Cockpit modules, Volvo IPS-controller
- Volvo Penta specifics: Bosch EDC17 marine-specific — peak hp increase accounting for propeller load
Service terms:
- Calibrations are done by hand in WinOLS5 + Ghidra for each specific control unit
- Checksums are recalculated on the engineer's side — the file is ready to flash with a current programmer
- File returned within 30-60 minutes during working hours
- Free revisions based on an OBD log