Subaru Forester 2.0ie e-BOXER 150 hp — Stage 1 file
hp
Stage 1 file for Subaru Forester 2.0ie e-BOXER 150 hp
Target +0 hp. Custom development for your engine.
Chip tuning for Subaru Forester 2.0ie e-BOXER 150 hp ECU
Subaru Forester (2019) 2.0ie e-BOXER 150 hp — mass-market hybrid engine of the passenger segment of the Subaru Corporation (Toyota владеет 20%) group (Япония, 1953). In the CHIPOK database: 2 configurations.
The boxer (flat) layout is Subaru's signature engine architecture. STI (Subaru Tecnica International) is the performance division that builds the WRX STI. Subaru uses permanent all-wheel drive (AWD) on most of its models. e-Boxer is the brand's hybrid technology. The Subaru Solterra is the flagship electric crossover built on the Toyota bZ4X platform.
The Subaru community in JDM and rally culture is the largest for the WRX/STI. Mid-range Subaru models use naturally aspirated Boxer engines with a conservative calibration.
Frequently asked questions
What is Stage 1 chip tuning for the Subaru Forester?
Stage 1 on the Subaru Forester 2.0ie e-BOXER 150 hp is a software ECU calibration with no hardware changes. The key maps (boost/ignition/lambda/torque) are adjusted while factory tolerances are preserved.
Is a Stage 1 remap safe for the 2.0ie e-BOXER 150 hp?
Stage 1 on the Subaru Forester 2.0ie e-BOXER 150 hp is developed while keeping the factory AFR, knock control and temperature limits. Engine life is preserved provided regular maintenance is carried out.
How does Stage 2 differ from Stage 1 on the Subaru Forester 2.0ie e-BOXER 150 hp?
Stage 2 on the Subaru Forester 2.0ie e-BOXER 150 hp means software + hardware (exhaust, intake, intercooler). The gain depends on the specific hardware combination.
Does Stage 1 void the warranty on the Subaru Forester?
Stage 1 on the Subaru Forester voids the factory warranty on the engine and transmission — this is standard for all manufacturers. CHIPOK provides its own warranty on the quality of the remap.
How quickly is chip tuning of the Subaru Forester 2.0ie e-BOXER 150 hp done?
The full remap cycle for the Subaru Forester — from reading to writing the final file — takes 30-90 minutes depending on the ECU access method. The file is prepared at CHIPOK in 5-30 minutes.
Can you return to stock after Stage 1 on the Subaru Forester?
The original Subaru Forester ECU is always saved before flashing. Rolling back to the factory firmware is done with the same programmer in 25-30 minutes.
How much does Stage 1 cost for the Subaru Forester 2.0ie e-BOXER 150 hp?
The cost of Stage 1 for the Subaru Forester 2.0ie e-BOXER 150 hp is calculated in the calculator on this page — you select the options (DPF off, EGR off, AdBlue off, DTC off, etc.) and the price is capped by the package Max Price. Payment is by credits (1 cr = 1 €), with no subscriptions.