MAN TGX TGX 430 430hp (316kW) 2100Nm — Stage 1 file (+65 hp)
hp
Stage 1 file for MAN TGX TGX 430 430hp (316kW) 2100Nm
Target +0 hp. Custom development for your engine.
Chip tuning for MAN TGX TGX 430 430hp (316kW) 2100Nm ECU
MAN TGX (I) TGX 430 430hp (316kW) 2100Nm — commercial diesel engine of the commercial segment of the TRATON Group (Volkswagen Truck & Bus) group (Германия, 1758). Stage 1 chip tuning raises power from 430 to 495 hp (+65 hp, +15%) and torque from 2100 to 2415 Nm (+315 Nm).
MAN specialises in heavy trucks and long-haul tractor units. MAN shares some engines and platforms with Scania within TRATON. MAN is part of the TRATON Group (the Volkswagen Truck & Bus division). Truck diesels carry an extended set of maps for commercial load, with the focus on torque. DPF/SCR with AdBlue is standard on modern Euro-6 truck engines. Truck chip tuning is a discipline of its own, focused on fuel consumption and pulling power rather than peak output.
The professional logistics segment tunes for fuel consumption and pulling characteristics. The truck chip tuning community is an industry of its own, focused on long-haul routes. Top MAN units sit at the power ceiling of the European truck segment.
Frequently asked questions
How much does the power of the MAN TGX TGX 430 430hp (316kW) 2100Nm increase after Stage 1?
The Stage 1 gain for the MAN TGX TGX 430 430hp (316kW) 2100Nm is 65 hp (+15%) over the stock 430 hp, for a total of 495 hp. Torque rises from 2100 to 2415 Nm (+315 Nm).
What is Stage 1 chip tuning for the MAN TGX?
Stage 1 on the MAN TGX TGX 430 430hp (316kW) 2100Nm is a software ECU calibration with no hardware changes. The key maps (boost/ignition/lambda/torque) are adjusted while factory tolerances are preserved. The gain is +65 hp with no hardware changes.
What does Stage 1 give on the top-spec MAN TGX TGX 430 430hp (316kW) 2100Nm?
Stage 1 for the MAN TGX TGX 430 430hp (316kW) 2100Nm unlocks the potential built in by the factory but artificially capped to meet mass-market targets. A base of 750-800 hp is achievable once hardware is added.
How does Stage 2 differ from Stage 1 on the MAN TGX TGX 430 430hp (316kW) 2100Nm?
Stage 2 on the MAN TGX TGX 430 430hp (316kW) 2100Nm means software + hardware (exhaust, intake, intercooler). The gain depends on the specific hardware combination.
Does Stage 1 void the warranty on the MAN TGX?
Stage 1 on the MAN TGX voids the factory warranty on the engine and transmission — this is standard for all manufacturers. CHIPOK provides its own warranty on the quality of the remap.
How quickly is chip tuning of the MAN TGX TGX 430 430hp (316kW) 2100Nm done?
The full remap cycle for the MAN TGX — from reading to writing the final file — takes 30-90 minutes depending on the ECU access method. The file is prepared at CHIPOK in 5-30 minutes.
Can you return to stock after Stage 1 on the MAN TGX?
The original MAN TGX ECU is always saved before flashing. Rolling back to the factory firmware is done with the same programmer in 25-30 minutes.
How much does Stage 1 cost for the MAN TGX TGX 430 430hp (316kW) 2100Nm?
The cost of Stage 1 for the MAN TGX TGX 430 430hp (316kW) 2100Nm is calculated in the calculator on this page — you select the options (DPF off, EGR off, AdBlue off, DTC off, etc.) and the price is capped by the package Max Price. Payment is by credits (1 cr = 1 €), with no subscriptions.