Land-Rover Rover 3.0 P510e PHEV 510 hp — Stage 1 file (+40 hp)
hp
Stage 1 file for Land-Rover Rover 3.0 P510e PHEV 510 hp
Target +0 hp. Custom development for your engine.
Chip tuning for Land-Rover Rover 3.0 P510e PHEV 510 hp ECU
Land-Rover Rover (2022) 3.0 P510e PHEV 510 hp — premium hybrid engine of the passenger segment of the Tata Motors (Jaguar Land Rover) group (Великобритания, 1922). Stage 1 chip tuning raises power from 510 to 550 hp (+40 hp, +8%) and torque from 700 to 800 Nm (+100 Nm). ECU — Bosch MG1CS028. Flashing method: OBD or Bench depending on the unit's protection. The ZF 8HPxx TCU is calibrated with a separate file — torque limiter and shift maps for Stage 1. In the CHIPOK database: 2 configurations · 2 ECU variants.
Land Rover shares platforms and engines with Jaguar within JLR. Land Rover is a British manufacturer of premium off-roaders and SUVs, founded in 1948. Land Rover is part of Tata Motors via Jaguar Land Rover (JLR). The Jaguar I-PACE is the flagship electric crossover. Jaguar PHEV variants appear in the E-Pace and F-Pace range. On all-electric Jaguars, the inverter and BMS are locked.
Modern Jaguars use Tricore protection and often require a Bench read. The supercharged Jaguar V8 comfortably reaches Stage 2 with the right hardware. The Jaguar community is a premium chip tuning niche in the UK and Europe. The top Jaguar SVR engines (supercharged V8) mark the ceiling of British premium performance.
SVR models use a reinforced ZF 8HP. Jaguar uses the ZF 8HP, a premium 8-speed automatic.
Frequently asked questions
How many horsepower does the Land-Rover Rover 3.0 P510e PHEV 510 hp reach after a remap?
Stage 1 for the Land-Rover Rover 3.0 P510e PHEV 510 hp adds +40 hp — power increases from 510 to 550 hp (+8%). Torque rises from 700 to 800 Nm (+100 Nm).
What does a Stage 1 remap of the Land-Rover Rover 3.0 P510e PHEV 510 hp include?
Stage 1 on the Land-Rover Rover 3.0 P510e PHEV 510 hp is a software ECU calibration with no hardware changes. The key maps (boost/ignition/lambda/torque) are adjusted while factory tolerances are preserved. The gain is +40 hp with no hardware changes.
What does Stage 1 give on the top-spec Land-Rover Rover 3.0 P510e PHEV 510 hp?
On the top-spec Land-Rover Rover 3.0 P510e PHEV 510 hp engine, Stage 1 is the starting point before Stage 2 with a downpipe, intake and a larger intercooler. The mass-market factory calibration leaves substantial headroom for an aggressive software tune.
How does Stage 2 differ from Stage 1 on the Land-Rover Rover 3.0 P510e PHEV 510 hp?
Stage 2 for the Land-Rover Rover 3.0 P510e PHEV 510 hp is Stage 1 plus hardware changes: a downpipe, a larger intake and a performance intercooler. The gain is considerably higher, but it requires professional component selection.
What control unit does the Land-Rover Rover 3.0 P510e PHEV 510 hp run?
The control unit of the Land-Rover Rover 3.0 P510e PHEV 510 hp is the Bosch MG1CS028. Before flashing, the engineer identifies the exact revision and selects the write method.
Does the ZF 8HPxx transmission need calibration after Stage 1 on the Land-Rover Rover?
Remapping the ZF 8HPxx gearbox is essential to fully unlock Stage 1 on the Land-Rover Rover 3.0 P510e PHEV 510 hp. Without a TCU update the factory torque cap will choke the torque gain and shifts will become noticeably softer.
Does Stage 1 void the warranty on the Land-Rover Rover?
Stage 1 on the Land-Rover Rover voids the factory warranty on the engine and transmission — this is standard for all manufacturers. CHIPOK provides its own warranty on the quality of the remap.
How quickly is chip tuning of the Land-Rover Rover 3.0 P510e PHEV 510 hp done?
The full remap cycle for the Land-Rover Rover — from reading to writing the final file — takes 30-90 minutes depending on the ECU access method. The file is prepared at CHIPOK in 5-30 minutes.
Can you return to stock after Stage 1 on the Land-Rover Rover?
The original Land-Rover Rover ECU is always saved before flashing. Rolling back to the factory firmware is done with the same programmer in 25-30 minutes.
How much does Stage 1 cost for the Land-Rover Rover 3.0 P510e PHEV 510 hp?
The cost of Stage 1 for the Land-Rover Rover 3.0 P510e PHEV 510 hp is calculated in the calculator on this page — you select the options (DPF off, EGR off, AdBlue off, DTC off, etc.) and the price is capped by the package Max Price. Payment is by credits (1 cr = 1 €), with no subscriptions.