Land-Rover Rover 3.0 P440e PHEV 440 hp — Stage 1 file (+110 hp)
hp
Stage 1 file for Land-Rover Rover 3.0 P440e PHEV 440 hp
Target +0 hp. Custom development for your engine.
Chip tuning for Land-Rover Rover 3.0 P440e PHEV 440 hp ECU
Land-Rover Rover (2022) 3.0 P440e PHEV 440 hp — premium hybrid engine of the passenger segment of the Tata Motors (Jaguar Land Rover) group (Великобритания, 1922). Stage 1 chip tuning raises power from 440 to 550 hp (+110 hp, +25%) and torque from 620 to 800 Nm (+180 Nm). ECU — Bosch MG1CS028. Flashing method: OBD or Bench depending on the unit's protection. The ZF 8HPxx TCU is calibrated with a separate file — torque limiter and shift maps for Stage 1. In the CHIPOK database: 2 configurations · 2 ECU variants.
Land Rover specialises in premium off-roaders — the Range Rover, Discovery and Defender. The Range Rover is the flagship of the premium SUV segment and an iconic model for the brand. The Defender is an off-roader with a legendary reputation for capability. The Jaguar I-PACE is the flagship electric crossover. Jaguar PHEV variants appear in the E-Pace and F-Pace range. On all-electric Jaguars, the inverter and BMS are locked.
Modern Jaguars use Tricore protection and often require a Bench read. The supercharged Jaguar V8 comfortably reaches Stage 2 with the right hardware. The Jaguar community is a premium chip tuning niche in the UK and Europe. The top Jaguar SVR engines (supercharged V8) mark the ceiling of British premium performance.
Jaguar uses the ZF 8HP, a premium 8-speed automatic. SVR models use a reinforced ZF 8HP.
Frequently asked questions
What is the Stage 1 effect on the Land-Rover Rover 3.0 P440e PHEV 440 hp?
After Stage 1 the power of the Land-Rover Rover 3.0 P440e PHEV 440 hp rises from 440 to 550 hp, a gain of 110 hp (+25%). Torque rises from 620 to 800 Nm (+180 Nm).
How does Stage 1 differ from stock on the Land-Rover Rover?
Stage 1 on the Land-Rover Rover 3.0 P440e PHEV 440 hp is a software ECU calibration with no hardware changes. The key maps (boost/ignition/lambda/torque) are adjusted while factory tolerances are preserved. The gain is +110 hp with no hardware changes.
What does Stage 1 give on the top-spec Land-Rover Rover 3.0 P440e PHEV 440 hp?
Stage 1 for the Land-Rover Rover 3.0 P440e PHEV 440 hp unlocks the potential built in by the factory but artificially capped to meet mass-market targets. A base of 750-800 hp is achievable once hardware is added.
How does Stage 2 differ from Stage 1 on the Land-Rover Rover 3.0 P440e PHEV 440 hp?
Stage 2 on the Land-Rover Rover 3.0 P440e PHEV 440 hp means software + hardware (exhaust, intake, intercooler). The gain depends on the specific hardware combination.
What control unit does the Land-Rover Rover 3.0 P440e PHEV 440 hp run?
The control unit of the Land-Rover Rover 3.0 P440e PHEV 440 hp is the Bosch MG1CS028. Before flashing, the engineer identifies the exact revision and selects the write method.
Does the ZF 8HPxx transmission need calibration after Stage 1 on the Land-Rover Rover?
Remapping the ZF 8HPxx gearbox is essential to fully unlock Stage 1 on the Land-Rover Rover 3.0 P440e PHEV 440 hp. Without a TCU update the factory torque cap will choke the torque gain and shifts will become noticeably softer.
Does Stage 1 void the warranty on the Land-Rover Rover?
Stage 1 on the Land-Rover Rover voids the factory warranty on the engine and transmission — this is standard for all manufacturers. CHIPOK provides its own warranty on the quality of the remap.
How quickly is chip tuning of the Land-Rover Rover 3.0 P440e PHEV 440 hp done?
The full remap cycle for the Land-Rover Rover — from reading to writing the final file — takes 30-90 minutes depending on the ECU access method. The file is prepared at CHIPOK in 5-30 minutes.
Can you return to stock after Stage 1 on the Land-Rover Rover?
The original Land-Rover Rover ECU is always saved before flashing. Rolling back to the factory firmware is done with the same programmer in 25-30 minutes.
How much does Stage 1 cost for the Land-Rover Rover 3.0 P440e PHEV 440 hp?
The cost of Stage 1 for the Land-Rover Rover 3.0 P440e PHEV 440 hp is calculated in the calculator on this page — you select the options (DPF off, EGR off, AdBlue off, DTC off, etc.) and the price is capped by the package Max Price. Payment is by credits (1 cr = 1 €), with no subscriptions.