Iveco Trakker T31 310hp (228kW) 1115Nm — Stage 1 file
hp
Stage 1 file for Iveco Trakker T31 310hp (228kW) 1115Nm
Target +0 hp. Custom development for your engine.
Chip tuning for Iveco Trakker T31 310hp (228kW) 1115Nm ECU
Iveco Trakker (I) T31 310hp (228kW) 1115Nm — commercial diesel engine of the commercial segment of the Iveco Group / CNH Industrial group (Италия, 1975).
The Iveco Daily is a high-volume commercial van in Europe. The Iveco Stralis and S-Way are long-haul tractor units. Cursor is the range of Iveco/CNH commercial diesel engines. Truck chip tuning is a discipline of its own, focused on fuel consumption and pulling power rather than peak output. DPF/SCR with AdBlue is standard on modern Euro-6 truck engines. Truck diesels carry an extended set of maps for commercial load, with the focus on torque.
The truck chip tuning community is an industry of its own, focused on long-haul routes. On high-output trucks, Stage 1 reduces fuel consumption under load. The professional logistics segment tunes for fuel consumption and pulling characteristics. High-output MAN units are long-haul tractors with solid headroom for Stage 1.
Frequently asked questions
How much horsepower does Stage 1 add for the Iveco Trakker T31 310hp (228kW) 1115Nm?
The Stage 1 gain for the Iveco Trakker T31 310hp (228kW) 1115Nm is 0 hp (+0%) over the stock 310 hp, for a total of 310 hp. Torque rises from 1115 to 1270 Nm (+155 Nm).
What is Stage 1 chip tuning for the Iveco Trakker?
Stage 1 on the Iveco Trakker T31 310hp (228kW) 1115Nm is a software ECU calibration with no hardware changes. The key maps (boost/ignition/lambda/torque) are adjusted while factory tolerances are preserved. The gain is +0 hp with no hardware changes.
What does Stage 1 give on the powerful Iveco Trakker T31 310hp (228kW) 1115Nm?
The high-output Iveco Trakker T31 310hp (228kW) 1115Nm has a conservative factory calibration aimed at the mass market. Stage 1 unlocks the engine's real potential while turbo and injector life are preserved.
How does Stage 2 differ from Stage 1 on the Iveco Trakker T31 310hp (228kW) 1115Nm?
Stage 2 on the Iveco Trakker T31 310hp (228kW) 1115Nm means software + hardware (exhaust, intake, intercooler). The gain depends on the specific hardware combination.
Does Stage 1 void the warranty on the Iveco Trakker?
Stage 1 on the Iveco Trakker voids the factory warranty on the engine and transmission — this is standard for all manufacturers. CHIPOK provides its own warranty on the quality of the remap.
How quickly is chip tuning of the Iveco Trakker T31 310hp (228kW) 1115Nm done?
The full remap cycle for the Iveco Trakker — from reading to writing the final file — takes 30-90 minutes depending on the ECU access method. The file is prepared at CHIPOK in 5-30 minutes.
Can you return to stock after Stage 1 on the Iveco Trakker?
The original Iveco Trakker ECU is always saved before flashing. Rolling back to the factory firmware is done with the same programmer in 25-30 minutes.
How much does Stage 1 cost for the Iveco Trakker T31 310hp (228kW) 1115Nm?
The cost of Stage 1 for the Iveco Trakker T31 310hp (228kW) 1115Nm is calculated in the calculator on this page — you select the options (DPF off, EGR off, AdBlue off, DTC off, etc.) and the price is capped by the package Max Price. Payment is by credits (1 cr = 1 €), with no subscriptions.