Iveco Daily 2.3 HPI 106 hp — Stage 1 file (+54 hp)
hp
Stage 1 file for Iveco Daily 2.3 HPI 106 hp
Target +0 hp. Custom development for your engine.
Chip tuning for Iveco Daily 2.3 HPI 106 hp ECU
Iveco Daily (2011) 2.3 HPI 106 hp — commercial diesel engine of the passenger segment of the Iveco Group / CNH Industrial group (Италия, 1975). Stage 1 chip tuning raises power from 106 to 160 hp (+54 hp, +51%) and torque from 270 to 340 Nm (+70 Nm). This engine ships with different ECU variants: Bosch EDC16C39, Bosch EDC17C49. The flashing method is determined by the specific unit: OBD, Bench or Boot mode. The ZF 8HP70 TCU is calibrated with a separate file — torque limiter and shift maps for Stage 1. In the CHIPOK database: 3 configurations · 3 ECU variants. The 2011 generation — mid-generation diesels on the EDC17 platform with OBD reading support and no need for Bench.
Iveco is an Italian manufacturer of trucks and commercial vehicles, founded in 1975. Iveco is part of the Iveco Group (spun off from CNH Industrial in 2022). The Iveco Daily is a high-volume commercial van in Europe. Mid-range diesels are a mainstream chip tuning subject in the commercial segment. The factory calibration is conservative, leaving headroom for Stage 1 while preserving engine life. Truck chip tuning is a discipline of its own, focused on fuel consumption and pulling power rather than peak output.
Stage 1 on truck diesels focuses on torque for loaded running. The professional logistics segment tunes for fuel consumption and pulling characteristics. The truck chip tuning community is an industry of its own, focused on long-haul routes. Mid-range MAN trucks are a mainstream chip tuning subject in logistics.
TipMatic is MAN's proprietary automated gearbox. The TCU on trucks needs recalibration at Stage 1+. MAN uses ZF-series and its own TipMatic gearboxes.
Frequently asked questions
How much does the power of the Iveco Daily 2.3 HPI 106 hp increase after Stage 1?
After Stage 1 the power of the Iveco Daily 2.3 HPI 106 hp rises from 106 to 160 hp, a gain of 54 hp (+51%). Torque rises from 270 to 340 Nm (+70 Nm).
How does Stage 1 differ from stock on the Iveco Daily?
Stage 1 is a software optimization of the factory ECU firmware of the Iveco Daily with no hardware changes. The injection, boost, ignition-timing and torque maps are reprogrammed. The gain is +54 hp with no hardware changes.
What is the risk of Stage 1 on the Iveco Daily 2.3 HPI 106 hp?
A remap of the Iveco Daily 2.3 HPI 106 hp is safe — the factory calibration in this mid-range class is conservative, leaving genuine headroom for Stage 1 with no hardware changes.
What is Stage 2 for the Iveco Daily 2.3 HPI 106 hp?
Stage 2 on the Iveco Daily 2.3 HPI 106 hp means software + hardware (exhaust, intake, intercooler). The gain depends on the specific hardware combination.
Which control units is the Iveco Daily 2.3 HPI 106 hp built with?
The Iveco Daily 2.3 HPI 106 hp comes with 2 ECU variants: Bosch EDC16C39, Bosch EDC17C49. Calibration is done for the specific unit after the revision is identified.
What does remapping the ZF 8HP70 gearbox give on the Iveco Daily 2.3 HPI 106 hp?
The ZF 8HP70 TCU is calibrated separately: the torque limit is raised, the shift maps are optimized for the Stage 1 characteristics, and launch control is re-tuned. The TCU file is flashed separately from the ECU.
Does the factory warranty of the Iveco Daily remain valid after Stage 1?
After remapping the Iveco Daily, the official factory warranty on the engine and gearbox is lost (this applies to any manufacturer when the ECU is modified). CHIPOK guarantees the quality of the calibration and free revisions.
How long is the wait for a Stage 1 remap for the Iveco Daily?
Reading and writing via OBD takes 25-30 minutes on the Iveco Daily. Bench reading (BDM/JTAG) takes about 60 minutes plus refitting. Remote file processing at CHIPOK takes 5-30 minutes.
How do you roll back to the factory firmware of the Iveco Daily?
Before Stage 1 the original of the Iveco Daily 2.3 HPI 106 hp is read out and saved — returning to the factory state is possible at any time.
How much does chip tuning the Iveco Daily 2.3 HPI 106 hp cost?
The remap price for the Iveco Daily 2.3 HPI 106 hp is dynamic and is calculated in the CHIPOK calculator based on the selected options. A credit-based payment model, with no subscription fees.