Magneti Marelli IAW4.CV Immo Off

Magneti Marelli IAW4.CV Immo Off

Immo Off is disabling the immobilizer right in the engine control unit's firmware. After the operation the ECU stops checking the key tag against the BCM, CAS or EWS and starts the engine without binding to the car.

When you need Immo Off

• Installing a used (donor) unit — an ECU from another car is not matched to your key and BCM.
• Lost or broken keys — you need to start the engine while keys are being restored.
• Board repair or processor replacement — after servicing, the immobilizer binding is lost.
• Moving the ECU to a bench — starting the engine outside the car, without the factory security system.

What you get: the unit starts the engine without the immobilizer — the key tag and BCM are no longer checked.

Magneti Marelli IAW4.CV memory and reading

The Magneti Marelli IAW4.CV unit uses the following: EXT EEPROM — ST95040. The Immo Off operation works on the EXT EEPROM [ST95040] area — that is the one to read out and upload. If OBD reading is not available for this unit, the dump is taken on the bench via Bench or Boot mode.

For the Magneti Marelli IAW4.CV block the «Immo Off» operation runs online from the ECU memory dump (access — EXT EEPROM [ST95040]). Read the file via OBD, Bench or Boot and upload it — the system detects Magneti Marelli IAW4.CV and checks whether the operation applies for free. You'll get the ready file with recalculated checksums in your portal account.