Ezs W906/CRAFTER Odo+VIN Edit
Odo+VIN Edit on the Ezs W906/CRAFTER control unit for your vehicle. Upload the dump — free analysis and check; apply the operation and download the ready file in your portal account.
Editing mileage and VIN in an instrument-cluster or control-unit dump — aligning the data after a module swap.
| Operation | Odo+VIN Edit |
|---|---|
| Control unit | Ezs W906/CRAFTER |
| Access / memory | — |
| Method | Online, from the ECU memory dump (.bin) |
| Applicability check | Free |
| Checksums | Recalculated automatically |
| Result | A ready file to write to the unit |
Ezs W906/CRAFTER Odo+VIN Edit
Odometer and VIN editing corrects the values inside an instrument cluster or control unit dump so that the reading and the identifier match the car. The values are kept in several copies protected by checksums, which makes editing them by hand in a hex editor risky.
When you need Odo+VIN Edit
- Instrument cluster replacement — a used cluster shows someone else's mileage and VIN.
- Board repair or EEPROM replacement — after the work the values are lost or corrupted.
- Modules out of sync — the cluster and the ECU report different mileage and the car logs a fault.
- Bringing the VIN in line — the identifier in the module must match the body of the car.
What you get: mileage and VIN are consistent across every copy, checksums recalculated.
For the Ezs W906/CRAFTER block the «Odo+VIN Edit» operation runs online from the ECU memory dump (access — —). Read the file via OBD, Bench or Boot and upload it — the system detects Ezs W906/CRAFTER and checks whether the operation applies for free. You'll get the ready file with recalculated checksums in your portal account.
Frequently asked questions
Odo+VIN Edit on Ezs W906/CRAFTER — short and to the point
What does Odo+VIN Edit do on Ezs W906/CRAFTER?
Editing mileage and VIN in an instrument-cluster or control-unit dump — aligning the data after a module swap.
Which file should I upload?
The ECU memory dump (access —), read via OBD, Bench or Boot. Upload the file — the system detects Ezs W906/CRAFTER for free and checks whether the operation applies.
How much does Odo+VIN Edit cost?
Uploading and analyzing the file is free. Applying the operation and downloading the ready file happen in your portal account (40 €).
Are the checksums recalculated?
Yes, automatically. The ready file is immediately writable to the unit — no need to recalculate checksums by hand.