Bosch MEVD17.2.G ISN+VIN Edit: Alpina · BMW

Bosch MEVD17.2.G ISN+VIN Edit — for Alpina, BMW

The ISN (Individual Serial Number) is a unique serial number by which the engine control unit syncs with BMW's security system: CAS, EWS or FEM/BDC. Without a matching ISN the unit won't start the engine.

When you need ISN+VIN Edit

• ECU replacement or repair — the new unit must pair with your car's CAS/FEM.
• Read ISN — read the serial number from the dump to match it with other units.
• Write ISN — write into the ECU a number matching the car's security system.
• Recovery after a failed write — restore the unit to working order.

What you get: the ISN in the unit matches the security system — the engine starts normally.

Bosch MEVD17.2.G memory and reading

The Bosch MEVD17.2.G unit uses the following: INT FLASH — TC1797, INT EEPROM — TC1797. The ISN+VIN Edit operation works on the INT FLASH [TC1797] · INT EEPROM [TC1797] area — that is the one to read out and upload. If OBD reading is not available for this unit, the dump is taken on the bench via Bench or Boot mode.

For the Bosch MEVD17.2.G block the «ISN+VIN Edit» operation runs online from the ECU memory dump (access — INT FLASH [TC1797] · INT EEPROM [TC1797]). Read the file via OBD, Bench or Boot and upload it — the system detects Bosch MEVD17.2.G and checks whether the operation applies for free. You'll get the ready file with recalculated checksums in your portal account.