Volvo Penta D6 350 Marine 350hp (257kW) 870Nm — Stage 1 file (+60 hp)
hp
Stage 1 file for Volvo Penta D6 350 Marine 350hp (257kW) 870Nm
Target +0 hp. Custom development for your engine.
Chip tuning for Volvo Penta D6 350 Marine 350hp (257kW) 870Nm ECU
Volvo Penta D6 350 (I) Marine 350hp (257kW) 870Nm — marine diesel engine of the marine segment of the Volvo Group group (Швеция, 1907). Stage 1 chip tuning raises power from 350 to 410 hp (+60 hp, +17%) and torque from 870 to 990 Nm (+120 Nm).
Volvo Penta IPS is a signature propulsion system with steerable pods. Volvo Penta is the marine and industrial division of the Volvo Group, founded in 1907. Volvo Penta specialises in marine inboard engines and industrial diesels. The Volvo Penta D-series is a range of marine diesel engines.
Marine engines are a specialised chip tuning segment focused on torque and fuel consumption. Marine chip tuning is a narrow niche, with calibration tailored to propeller load and operating conditions. The top Mercury Marine units sit at the power ceiling of the marine segment.
Frequently asked questions
What power gain do you get after chip tuning the Volvo Penta D6 350 Marine 350hp (257kW) 870Nm?
The Stage 1 gain for the Volvo Penta D6 350 Marine 350hp (257kW) 870Nm is 60 hp (+17%) over the stock 350 hp, for a total of 410 hp. Torque rises from 870 to 990 Nm (+120 Nm).
What is Stage 1 chip tuning for the Volvo Penta D6 350?
Stage 1 on the Volvo Penta D6 350 Marine 350hp (257kW) 870Nm is a software ECU calibration with no hardware changes. The key maps (boost/ignition/lambda/torque) are adjusted while factory tolerances are preserved. The gain is +60 hp with no hardware changes.
What does Stage 1 give on the top-spec Volvo Penta D6 350 Marine 350hp (257kW) 870Nm?
Stage 1 for the Volvo Penta D6 350 Marine 350hp (257kW) 870Nm unlocks the potential built in by the factory but artificially capped to meet mass-market targets. A base of 750-800 hp is achievable once hardware is added.
How does Stage 2 differ from Stage 1 on the Volvo Penta D6 350 Marine 350hp (257kW) 870Nm?
Stage 2 on the Volvo Penta D6 350 Marine 350hp (257kW) 870Nm means software + hardware (exhaust, intake, intercooler). The gain depends on the specific hardware combination.
Does Stage 1 void the warranty on the Volvo Penta D6 350?
Stage 1 on the Volvo Penta D6 350 voids the factory warranty on the engine and transmission — this is standard for all manufacturers. CHIPOK provides its own warranty on the quality of the remap.
How quickly is chip tuning of the Volvo Penta D6 350 Marine 350hp (257kW) 870Nm done?
The full remap cycle for the Volvo Penta D6 350 — from reading to writing the final file — takes 30-90 minutes depending on the ECU access method. The file is prepared at CHIPOK in 5-30 minutes.
Can you return to stock after Stage 1 on the Volvo Penta D6 350?
The original Volvo Penta D6 350 ECU is always saved before flashing. Rolling back to the factory firmware is done with the same programmer in 25-30 minutes.
How much does Stage 1 cost for the Volvo Penta D6 350 Marine 350hp (257kW) 870Nm?
The cost of Stage 1 for the Volvo Penta D6 350 Marine 350hp (257kW) 870Nm is calculated in the calculator on this page — you select the options (DPF off, EGR off, AdBlue off, DTC off, etc.) and the price is capped by the package Max Price. Payment is by credits (1 cr = 1 €), with no subscriptions.