Skoda Fabia 1.0 TSI/TFSI 95 hp — Stage 1 file (+25 hp)
hp
Stage 1 file for Skoda Fabia 1.0 TSI/TFSI 95 hp
Target +0 hp. Custom development for your engine.
Chip tuning for Skoda Fabia 1.0 TSI/TFSI 95 hp ECU
Skoda Fabia (2015) 1.0 TSI/TFSI 95 hp — mass-market petrol engine of the passenger segment of the Volkswagen Group (VAG) group (Чехия, 1895). Stage 1 chip tuning raises power from 95 to 120 hp (+25 hp, +26%) and torque from 175 to 235 Nm (+60 Nm). This engine ships with different ECU variants: Bosch MED17.1.27, Bosch MED17.5.21. The flashing method is determined by the specific unit: OBD, Bench or Boot mode. In the CHIPOK database: 4 configurations · 2 ECU variants. The 2015 generation — mid-generation petrol ECUs (MEDC17/MEVD17/Simos PCR), OBD flash on production revisions.
Skoda's slogan is “Simply Clever”. RS is Skoda's performance sub-brand, the equivalent of VW's GTI. The Skoda range covers compacts, saloons, SUVs and family estates. The MQB platform allows ECU commonality with Volkswagen, Audi and Seat.
On Skoda, Stage 1 usually fits within the standard turnaround time. Within the VAG group, ECUs are standardised, so Skoda files often work on VW/Audi/Seat. The Skoda community benefits from a large pool of Stage files drawn from the shared VAG catalogue. On low-output Skoda engines, Stage 1 is safe without overstressing the hardware. On naturally aspirated Skoda engines, the main effect is on throttle response. In the Skoda city segment, Stage 1 is more about comfort than outright power.
Frequently asked questions
What is the Stage 1 effect on the Skoda Fabia 1.0 TSI/TFSI 95 hp?
The Stage 1 gain for the Skoda Fabia 1.0 TSI/TFSI 95 hp is 25 hp (+26%) over the stock 95 hp, for a total of 120 hp. Torque rises from 175 to 235 Nm (+60 Nm).
What is Stage 1 chip tuning for the Skoda Fabia?
Stage 1 is a software optimization of the factory ECU firmware of the Skoda Fabia with no hardware changes. The injection, boost, ignition-timing and torque maps are reprogrammed. The gain is +25 hp with no hardware changes.
Is Stage 1 worth doing on the base Skoda Fabia?
Stage 1 on the base Skoda Fabia is safe — the factory calibration of low-output engines leaves headroom for software optimization. The gain is modest, but engine life is not affected.
What is Stage 2 for the Skoda Fabia 1.0 TSI/TFSI 95 hp?
Stage 2 on the Skoda Fabia 1.0 TSI/TFSI 95 hp means software + hardware (exhaust, intake, intercooler). The gain depends on the specific hardware combination.
Which control units is the Skoda Fabia 1.0 TSI/TFSI 95 hp built with?
The Skoda Fabia 1.0 TSI/TFSI 95 hp comes with 2 ECU variants: Bosch MED17.1.27, Bosch MED17.5.21. Calibration is done for the specific unit after the revision is identified.
Does the factory warranty of the Skoda Fabia remain valid after Stage 1?
After remapping the Skoda Fabia, the official factory warranty on the engine and gearbox is lost (this applies to any manufacturer when the ECU is modified). CHIPOK guarantees the quality of the calibration and free revisions.
How long is the wait for a Stage 1 remap for the Skoda Fabia?
Reading and writing via OBD takes 25-30 minutes on the Skoda Fabia. Bench reading (BDM/JTAG) takes about 60 minutes plus refitting. Remote file processing at CHIPOK takes 5-30 minutes.
How do you roll back to the factory firmware of the Skoda Fabia?
Before Stage 1 the original of the Skoda Fabia 1.0 TSI/TFSI 95 hp is read out and saved — returning to the factory state is possible at any time.
How much does chip tuning the Skoda Fabia 1.0 TSI/TFSI 95 hp cost?
The remap price for the Skoda Fabia 1.0 TSI/TFSI 95 hp is dynamic and is calculated in the CHIPOK calculator based on the selected options. A credit-based payment model, with no subscription fees.