Opel Combo 1.3 CDTI 70 hp — Stage 1 file (+20 hp)
hp
Stage 1 file for Opel Combo 1.3 CDTI 70 hp
Target +0 hp. Custom development for your engine.
Chip tuning for Opel Combo 1.3 CDTI 70 hp ECU
Opel Combo (2002) 1.3 CDTI 70 hp — mass-market diesel engine of the passenger segment of the Stellantis group (Германия, 1862). Stage 1 chip tuning raises power from 70 to 90 hp (+20 hp, +29%) and torque from 170 to 225 Nm (+55 Nm). ECU — Marelli MJD6. Flashing method: OBD or Bench depending on the unit's protection. In the CHIPOK database: 2 configurations. The 2002 generation — first-generation CDI/TDI/HDi diesels with relatively simple ECU protection; OBD reading works directly.
Opel and Vauxhall (UK) are the same line-up under different names. Opel OPC is the performance division, producing high-output turbo versions. Opel shares platforms with Peugeot, Citroen and DS within Stellantis since 2017. The factory calibration on Citroen diesels is conservative, leaving headroom for Stage 1.
Within Stellantis, ECUs are standardised, so Opel files (from 2017 on) often work on Peugeot/Citroen. Older Opel models (pre-2017) share ECUs with Chevrolet, requiring a different toolset. The Opel community in Germany and the UK generates a large volume of Stage files. Low-output Citroen engines are city units, and Stage 1 is safe. On naturally aspirated Citroen engines, the main effect is on throttle response.
Frequently asked questions
How many horsepower does the Opel Combo 1.3 CDTI 70 hp reach after a remap?
The Stage 1 gain for the Opel Combo 1.3 CDTI 70 hp is 20 hp (+29%) over the stock 70 hp, for a total of 90 hp. Torque rises from 170 to 225 Nm (+55 Nm).
What is Stage 1 chip tuning for the Opel Combo?
Stage 1 on the Opel Combo 1.3 CDTI 70 hp is a software ECU calibration with no hardware changes. The key maps (boost/ignition/lambda/torque) are adjusted while factory tolerances are preserved. The gain is +20 hp with no hardware changes.
Is Stage 1 safe for the low-output Opel Combo 1.3 CDTI 70 hp?
Stage 1 on the base Opel Combo is safe — the factory calibration of low-output engines leaves headroom for software optimization. The gain is modest, but engine life is not affected.
How does Stage 2 differ from Stage 1 on the Opel Combo 1.3 CDTI 70 hp?
Stage 2 on the Opel Combo 1.3 CDTI 70 hp means software + hardware (exhaust, intake, intercooler). The gain depends on the specific hardware combination.
What control unit does the Opel Combo 1.3 CDTI 70 hp run?
The control unit of the Opel Combo 1.3 CDTI 70 hp is the Marelli MJD6. Before flashing, the engineer identifies the exact revision and selects the write method.
Does Stage 1 void the warranty on the Opel Combo?
Stage 1 on the Opel Combo voids the factory warranty on the engine and transmission — this is standard for all manufacturers. CHIPOK provides its own warranty on the quality of the remap.
How quickly is chip tuning of the Opel Combo 1.3 CDTI 70 hp done?
The full remap cycle for the Opel Combo — from reading to writing the final file — takes 30-90 minutes depending on the ECU access method. The file is prepared at CHIPOK in 5-30 minutes.
Can you return to stock after Stage 1 on the Opel Combo?
The original Opel Combo ECU is always saved before flashing. Rolling back to the factory firmware is done with the same programmer in 25-30 minutes.
How much does Stage 1 cost for the Opel Combo 1.3 CDTI 70 hp?
The cost of Stage 1 for the Opel Combo 1.3 CDTI 70 hp is calculated in the calculator on this page — you select the options (DPF off, EGR off, AdBlue off, DTC off, etc.) and the price is capped by the package Max Price. Payment is by credits (1 cr = 1 €), with no subscriptions.