Mercedes A 150 95 hp — Stage 1 file (+5 hp)
hp
Stage 1 file for Mercedes A 150 95 hp
Target +0 hp. Custom development for your engine.
Chip tuning for Mercedes A 150 95 hp ECU
Mercedes A (1997 - W168) 150 95 hp — premium petrol engine of the passenger segment of the Mercedes-Benz Group AG (Mercedes-Benz, AMG, Maybach, Smart, EQ) group (Германия, 1926). Stage 1 chip tuning raises power from 95 to 100 hp (+5 hp, +5%) and torque from 140 to 150 Nm (+10 Nm). ECU — Siemens/Continental SIM266. Flashing method: OBD or Bench depending on the unit's protection. The 1997 generation — old-era petrol ECUs (ME7/ME9/MED9/Simos) with easily readable memory.
The Mercedes three-pointed star symbolises dominance on land, at sea and in the air. 4MATIC all-wheel drive is Mercedes' signature system, fitted to most models. The Mercedes-Benz Group AG (Daimler AG until 2022) comprises Mercedes-Benz, AMG, Maybach, Smart and the EQ line. The Mercedes petrol range spans compacts, premium saloons, SUVs, roadsters and AMG flagships. Mercedes encryption is among the toughest in the industry, especially on modern models. Maybach uses Mercedes engines for the ultra-luxury segment, with the emphasis on quietness and smoothness.
The Mercedes community in Europe has a large pool of available Stage files for the standard models. The AMG community is active in Germany, but the protection is the toughest in the industry, so Stage 1 on AMG usually requires Bench. Mercedes is one of the most protected brands in the chip tuning industry in terms of encryption. In the Mercedes city segment, Stage 1 is more about comfort and responsiveness than power. On low-output Mercedes engines, Stage 1 is safe and does not over-stress the hardware. On naturally aspirated Mercedes engines without a turbo, the main effect is on throttle response.
Frequently asked questions
How many horsepower does the Mercedes A 150 95 hp reach after a remap?
The Stage 1 gain for the Mercedes A 150 95 hp is 5 hp (+5%) over the stock 95 hp, for a total of 100 hp. Torque rises from 140 to 150 Nm (+10 Nm).
What is Stage 1 chip tuning for the Mercedes A?
Stage 1 on the Mercedes A 150 95 hp is a software ECU calibration with no hardware changes. The key maps (boost/ignition/lambda/torque) are adjusted while factory tolerances are preserved. The gain is +5 hp with no hardware changes.
Is Stage 1 safe for the low-output Mercedes A 150 95 hp?
Stage 1 on the base Mercedes A is safe — the factory calibration of low-output engines leaves headroom for software optimization. The gain is modest, but engine life is not affected.
How does Stage 2 differ from Stage 1 on the Mercedes A 150 95 hp?
Stage 2 on the Mercedes A 150 95 hp means software + hardware (exhaust, intake, intercooler). The gain depends on the specific hardware combination.
What control unit does the Mercedes A 150 95 hp run?
The control unit of the Mercedes A 150 95 hp is the Siemens/Continental SIM266. Before flashing, the engineer identifies the exact revision and selects the write method.
Does Stage 1 void the warranty on the Mercedes A?
Stage 1 on the Mercedes A voids the factory warranty on the engine and transmission — this is standard for all manufacturers. CHIPOK provides its own warranty on the quality of the remap.
How quickly is chip tuning of the Mercedes A 150 95 hp done?
The full remap cycle for the Mercedes A — from reading to writing the final file — takes 30-90 minutes depending on the ECU access method. The file is prepared at CHIPOK in 5-30 minutes.
Can you return to stock after Stage 1 on the Mercedes A?
The original Mercedes A ECU is always saved before flashing. Rolling back to the factory firmware is done with the same programmer in 25-30 minutes.
How much does Stage 1 cost for the Mercedes A 150 95 hp?
The cost of Stage 1 for the Mercedes A 150 95 hp is calculated in the calculator on this page — you select the options (DPF off, EGR off, AdBlue off, DTC off, etc.) and the price is capped by the package Max Price. Payment is by credits (1 cr = 1 €), with no subscriptions.