McLaren Artura 3.0 T V6 hybrid 680 hp — Stage 1 file
hp
Stage 1 file for McLaren Artura 3.0 T V6 hybrid 680 hp
Target +0 hp. Custom development for your engine.
Chip tuning for McLaren Artura 3.0 T V6 hybrid 680 hp ECU
McLaren Artura (2021) 3.0 T V6 hybrid 680 hp — luxury hybrid engine of the passenger segment of the McLaren Automotive group (Великобритания, 1985).
McLaren is a British supercar manufacturer, founded in 1985. McLaren specialises in track-focused supercars. McLaren uses its own M838T/M840T V8 BiTurbo engines. The McLaren Artura is a hybrid supercar combining a V6 BiTurbo with an electric motor.
With the right hardware, McLaren comfortably reaches Stage 2. The McLaren community is an ultra-premium track segment and a narrow niche. Protection on modern McLaren models is tight, so Bench is required. Top-tier McLaren engines sit at the power ceiling of the British track segment.
Frequently asked questions
What is Stage 1 chip tuning for the McLaren Artura?
Stage 1 is a software optimization of the factory ECU firmware of the McLaren Artura with no hardware changes. The injection, boost, ignition-timing and torque maps are reprogrammed.
Does Stage 1 make sense on the McLaren Artura 3.0 T V6 hybrid 680 hp with this much power?
Stage 1 for the McLaren Artura 3.0 T V6 hybrid 680 hp unlocks the potential built in by the factory but artificially capped to meet mass-market targets. A base of 750-800 hp is achievable once hardware is added.
What is Stage 2 for the McLaren Artura 3.0 T V6 hybrid 680 hp?
Stage 2 on the McLaren Artura 3.0 T V6 hybrid 680 hp means software + hardware (exhaust, intake, intercooler). The gain depends on the specific hardware combination.
Does the factory warranty of the McLaren Artura remain valid after Stage 1?
After remapping the McLaren Artura, the official factory warranty on the engine and gearbox is lost (this applies to any manufacturer when the ECU is modified). CHIPOK guarantees the quality of the calibration and free revisions.
How long is the wait for a Stage 1 remap for the McLaren Artura?
Reading and writing via OBD takes 25-30 minutes on the McLaren Artura. Bench reading (BDM/JTAG) takes about 60 minutes plus refitting. Remote file processing at CHIPOK takes 5-30 minutes.
How do you roll back to the factory firmware of the McLaren Artura?
Before Stage 1 the original of the McLaren Artura 3.0 T V6 hybrid 680 hp is read out and saved — returning to the factory state is possible at any time.
How much does chip tuning the McLaren Artura 3.0 T V6 hybrid 680 hp cost?
The remap price for the McLaren Artura 3.0 T V6 hybrid 680 hp is dynamic and is calculated in the CHIPOK calculator based on the selected options. A credit-based payment model, with no subscription fees.