Iveco Daily E6 - 3.0 180 hp — Stage 1 file (+20 hp)
hp
Stage 1 file for Iveco Daily E6 - 3.0 180 hp
Target +0 hp. Custom development for your engine.
Chip tuning for Iveco Daily E6 - 3.0 180 hp ECU
Iveco Daily (2019) E6 - 3.0 180 hp — commercial diesel engine of the passenger segment of the Iveco Group / CNH Industrial group (Италия, 1975). Stage 1 chip tuning raises power from 180 to 200 hp (+20 hp, +11%) and torque from 430 to 480 Nm (+50 Nm). This engine ships with different ECU variants: Bosch DCU17PC43, Bosch EDC17C49. The flashing method is determined by the specific unit: OBD, Bench or Boot mode. The ZF 8HP70 TCU is calibrated with a separate file — torque limiter and shift maps for Stage 1. In the CHIPOK database: 6 configurations · 3 ECU variants. A 2019 diesel — a modern platform protected by RSA + checksum encryption; top models require BDM/JTAG.
Iveco is part of the Iveco Group (spun off from CNH Industrial in 2022). The Iveco Daily is a high-volume commercial van in Europe. The Iveco Stralis and S-Way are long-haul tractor units. DPF/SCR with AdBlue is standard on modern Euro-6 truck engines. Truck diesels carry an extended set of maps for commercial load, with the focus on torque. The Cursor 8/9/11 are for heavy trucks and special machinery.
The truck chip tuning community is an industry of its own, focused on long-haul routes. The professional logistics segment tunes for fuel consumption and pulling characteristics. Protection on modern trucks is Tricore, often requiring Bench. Mid-range MAN trucks are a mainstream chip tuning subject in logistics.
The TCU on trucks needs recalibration at Stage 1+. MAN uses ZF-series and its own TipMatic gearboxes. TipMatic is MAN's proprietary automated gearbox.
Frequently asked questions
How much horsepower does Stage 1 add for the Iveco Daily E6 - 3.0 180 hp?
Stage 1 chip tuning on the Iveco Daily E6 - 3.0 180 hp boosts engine output by 20 hp: from 180 to 200 hp. Torque rises from 430 to 480 Nm (+50 Nm).
What changes in the Iveco Daily ECU after Stage 1?
Stage 1 chip tuning of the Iveco Daily is a rework of the ECU maps: boost pressure, ignition advance, target lambda and the removal of factory torque limiters. The gain is +20 hp with no hardware changes.
Can you do Stage 1 on the Iveco Daily E6 - 3.0 180 hp?
Yes, Stage 1 for the Iveco Daily E6 - 3.0 180 hp stays within the factory limits for boost pressure, knock and temperature. On a healthy engine with a serviced turbo and injectors there is no risk.
How much does Stage 2 add on the Iveco Daily?
Stage 2 for the Iveco Daily E6 - 3.0 180 hp is Stage 1 plus hardware changes: a downpipe, a larger intake and a performance intercooler. The gain is considerably higher, but it requires professional component selection.
Which ECUs are found on the Iveco Daily E6 - 3.0 180 hp?
The Iveco Daily E6 - 3.0 180 hp was fitted with different ECUs depending on the year and trim: Bosch DCU17PC43, Bosch EDC17C49. The write method (OBD, Bench, Boot) is determined when the unit is read.
Is the ZF 8HP70 TCU calibrated together with Stage 1?
Yes, on the Iveco Daily E6 - 3.0 180 hp the ZF 8HP70 TCU is calibrated with a separate file. The torque limit, shift maps, launch control rpm and clutch torque map are changed. The factory torque limiter in the TCU is usually below what the engine can deliver after Stage 1.
What happens to the Iveco Daily warranty after chip tuning?
The factory warranty of the Iveco Daily does not remain valid after Stage 1 — the manufacturer withdraws its obligations once the ECU software is changed. CHIPOK provides its own warranty on its work and support.
How long does remapping the Iveco Daily take?
On the Iveco Daily E6 - 3.0 180 hp: OBD flash 25-30 minutes, Bench (if required) about an hour. The file processing itself takes 5-30 minutes once the original bin is received.
Is the original file kept when chip tuning the Iveco Daily?
Yes, the original ECU firmware of the Iveco Daily E6 - 3.0 180 hp is kept and can be flashed back at any time. Returning to stock via OBD takes 25-30 minutes.
What is the price of a Stage 1 remap for the Iveco Daily?
Stage 1 for the Iveco Daily E6 - 3.0 180 hp is paid for with CHIPOK credits (1 cr = 1 €). The final amount is set in the calculator, taking the extra options (off functions) into account.