Fiat 500 1.0 Mild Hybrid 69 hp — Stage 1 file
hp
Stage 1 file for Fiat 500 1.0 Mild Hybrid 69 hp
Target +0 hp. Custom development for your engine.
Chip tuning for Fiat 500 1.0 Mild Hybrid 69 hp ECU
Fiat 500 (2020) 1.0 Mild Hybrid 69 hp — mass-market hybrid engine of the passenger segment of the Stellantis (бывш. FCA — Fiat Chrysler Automobiles) group (Италия, 1899).
Fiat has historically specialised in compact and city cars. Fiat MHEV is a mild hybrid on the compact models. Fiat PHEV variants appear in the Ducato and crossover range. The Fiat 500e is the flagship electric Fiat on the Stellantis e-CMP platform.
Within Stellantis, ECUs are standardised across platforms, so some files work on Fiat/Citroen/Peugeot. Protection on modern Fiat models uses Tricore TPROT, so Bench is required. The Fiat community in Italy offers a large pool of ready-made Stage files for compacts and the Ducato. Low-output Fiat engines are city units, and Stage 1 is safe on them. On naturally aspirated Fiat engines the main effect is sharper throttle response.
Frequently asked questions
What is Stage 1 chip tuning for the Fiat 500?
Stage 1 on the Fiat 500 1.0 Mild Hybrid 69 hp is a software ECU calibration with no hardware changes. The key maps (boost/ignition/lambda/torque) are adjusted while factory tolerances are preserved.
Is Stage 1 safe for the low-output Fiat 500 1.0 Mild Hybrid 69 hp?
Stage 1 on the base Fiat 500 is safe — the factory calibration of low-output engines leaves headroom for software optimization. The gain is modest, but engine life is not affected.
How does Stage 2 differ from Stage 1 on the Fiat 500 1.0 Mild Hybrid 69 hp?
Stage 2 on the Fiat 500 1.0 Mild Hybrid 69 hp means software + hardware (exhaust, intake, intercooler). The gain depends on the specific hardware combination.
Does Stage 1 void the warranty on the Fiat 500?
Stage 1 on the Fiat 500 voids the factory warranty on the engine and transmission — this is standard for all manufacturers. CHIPOK provides its own warranty on the quality of the remap.
How quickly is chip tuning of the Fiat 500 1.0 Mild Hybrid 69 hp done?
The full remap cycle for the Fiat 500 — from reading to writing the final file — takes 30-90 minutes depending on the ECU access method. The file is prepared at CHIPOK in 5-30 minutes.
Can you return to stock after Stage 1 on the Fiat 500?
The original Fiat 500 ECU is always saved before flashing. Rolling back to the factory firmware is done with the same programmer in 25-30 minutes.
How much does Stage 1 cost for the Fiat 500 1.0 Mild Hybrid 69 hp?
The cost of Stage 1 for the Fiat 500 1.0 Mild Hybrid 69 hp is calculated in the calculator on this page — you select the options (DPF off, EGR off, AdBlue off, DTC off, etc.) and the price is capped by the package Max Price. Payment is by credits (1 cr = 1 €), with no subscriptions.