Ferrari 360 Modena/Spider 3.6 V8 32v 400 hp — Stage 1 file (+24 hp)

or choose step by step
1
Choose a vehicle type

Chip tuning for Ferrari 360 Modena/Spider 3.6 V8 32v 400 hp ECU

Ferrari 360 Modena/Spider (1999) 3.6 V8 32v 400 hp — luxury petrol engine of the passenger segment of the Ferrari N.V. (независимый, спин-офф из FCA в 2016) group (Италия, 1939). Stage 1 chip tuning raises power from 400 to 424 hp (+24 hp, +6%) and torque from 380 to 400 Nm (+20 Nm). ECU — Bosch ME7.3. Flashing method: OBD or Bench depending on the unit's protection. A petrol engine built in 1999 — the era before widespread firmware encryption, OBD flash without complications.

Ferrari has its own F1 works and a Grand Prix heritage dating back to the 1950s. Ferrari is an Italian supercar manufacturer from Maranello, founded in 1939 by Enzo Ferrari. Ferrari has been independent from Stellantis since 2016 (Ferrari N.V.). The Ferrari V8 and V12 are the brand's iconic engine families. Top-tier Ferrari engines have significant potential with a downpipe + intake. Ferrari's petrol range comprises high-output turbo and naturally aspirated top engines.

With the right hardware, Ferrari engines comfortably reach Stage 2. The Ferrari community is an ultra-premium chip tuning segment and a narrow niche. A Bench read is standard procedure on modern Ferraris. Top-tier Ferrari engines sit at the power ceiling of the supercar segment.

Frequently asked questions

What power gain do you get after chip tuning the Ferrari 360 Modena/Spider 3.6 V8 32v 400 hp?

Stage 1 for the Ferrari 360 Modena/Spider 3.6 V8 32v 400 hp adds +24 hp — power increases from 400 to 424 hp (+6%). Torque rises from 380 to 400 Nm (+20 Nm).

What does a Stage 1 remap of the Ferrari 360 Modena/Spider 3.6 V8 32v 400 hp include?

Stage 1 on the Ferrari 360 Modena/Spider 3.6 V8 32v 400 hp is a software ECU calibration with no hardware changes. The key maps (boost/ignition/lambda/torque) are adjusted while factory tolerances are preserved. The gain is +24 hp with no hardware changes.

What does Stage 1 give on the top-spec Ferrari 360 Modena/Spider 3.6 V8 32v 400 hp?

On the top-spec Ferrari 360 Modena/Spider 3.6 V8 32v 400 hp engine, Stage 1 is the starting point before Stage 2 with a downpipe, intake and a larger intercooler. The mass-market factory calibration leaves substantial headroom for an aggressive software tune.

How does Stage 2 differ from Stage 1 on the Ferrari 360 Modena/Spider 3.6 V8 32v 400 hp?

Stage 2 for the Ferrari 360 Modena/Spider 3.6 V8 32v 400 hp is Stage 1 plus hardware changes: a downpipe, a larger intake and a performance intercooler. The gain is considerably higher, but it requires professional component selection.

What control unit does the Ferrari 360 Modena/Spider 3.6 V8 32v 400 hp run?

The control unit of the Ferrari 360 Modena/Spider 3.6 V8 32v 400 hp is the Bosch ME7.3. Before flashing, the engineer identifies the exact revision and selects the write method.

Does Stage 1 void the warranty on the Ferrari 360 Modena/Spider?

Stage 1 on the Ferrari 360 Modena/Spider voids the factory warranty on the engine and transmission — this is standard for all manufacturers. CHIPOK provides its own warranty on the quality of the remap.

How quickly is chip tuning of the Ferrari 360 Modena/Spider 3.6 V8 32v 400 hp done?

The full remap cycle for the Ferrari 360 Modena/Spider — from reading to writing the final file — takes 30-90 minutes depending on the ECU access method. The file is prepared at CHIPOK in 5-30 minutes.

Can you return to stock after Stage 1 on the Ferrari 360 Modena/Spider?

The original Ferrari 360 Modena/Spider ECU is always saved before flashing. Rolling back to the factory firmware is done with the same programmer in 25-30 minutes.

How much does Stage 1 cost for the Ferrari 360 Modena/Spider 3.6 V8 32v 400 hp?

The cost of Stage 1 for the Ferrari 360 Modena/Spider 3.6 V8 32v 400 hp is calculated in the calculator on this page — you select the options (DPF off, EGR off, AdBlue off, DTC off, etc.) and the price is capped by the package Max Price. Payment is by credits (1 cr = 1 €), with no subscriptions.

Last updated: 31.08.2026 · Source: manufacturer technical documentation · Measurements: CHIPOK dyno