Chevrolet Silverado 6.6 Duramax 360 hp — Stage 1 file (+50 hp)
hp
Stage 1 file for Chevrolet Silverado 6.6 Duramax 360 hp
Target +0 hp. Custom development for your engine.
Chip tuning for Chevrolet Silverado 6.6 Duramax 360 hp ECU
Chevrolet Silverado (2007 - GMT 900) 6.6 Duramax 360 hp — mass-market diesel engine of the passenger segment of the General Motors group (США, 1911). Stage 1 chip tuning raises power from 360 to 410 hp (+50 hp, +14%) and torque from 881 to 1000 Nm (+119 Nm). ECU — Bosch EDC16C37. Flashing method: OBD or Bench depending on the unit's protection. The 2007 generation — first-generation CDI/TDI/HDi diesels with relatively simple ECU protection; OBD reading works directly.
The LS-series V8 is Chevrolet's iconic engine family (Camaro, Corvette). The Camaro and Corvette are Chevrolet's iconic muscle and sports cars. The Silverado is Chevrolet's flagship pickup. Duramax is the proprietary Chevrolet/GMC diesel range for pickups and trucks. DPF/SCR with AdBlue is standard on modern Duramax engines.
LS-swap is an industry of its own (Chevy LS engines into any car). HP Tuners is the primary tool for Chevrolet/GM in the US. The US Chevrolet community is the largest for Camaro, Corvette and LS-swaps. Top Chevrolet Corvette / Camaro ZL1 engines sit at the power ceiling of the American performance segment. HP Tuners is the leading tool for top Chevrolet models.
Frequently asked questions
What is the Stage 1 effect on the Chevrolet Silverado 6.6 Duramax 360 hp?
The Stage 1 gain for the Chevrolet Silverado 6.6 Duramax 360 hp is 50 hp (+14%) over the stock 360 hp, for a total of 410 hp. Torque rises from 881 to 1000 Nm (+119 Nm).
What is Stage 1 chip tuning for the Chevrolet Silverado?
Stage 1 on the Chevrolet Silverado 6.6 Duramax 360 hp is a software ECU calibration with no hardware changes. The key maps (boost/ignition/lambda/torque) are adjusted while factory tolerances are preserved. The gain is +50 hp with no hardware changes.
What does Stage 1 give on the top-spec Chevrolet Silverado 6.6 Duramax 360 hp?
Stage 1 for the Chevrolet Silverado 6.6 Duramax 360 hp unlocks the potential built in by the factory but artificially capped to meet mass-market targets. A base of 750-800 hp is achievable once hardware is added.
How does Stage 2 differ from Stage 1 on the Chevrolet Silverado 6.6 Duramax 360 hp?
Stage 2 on the Chevrolet Silverado 6.6 Duramax 360 hp means software + hardware (exhaust, intake, intercooler). The gain depends on the specific hardware combination.
What control unit does the Chevrolet Silverado 6.6 Duramax 360 hp run?
The control unit of the Chevrolet Silverado 6.6 Duramax 360 hp is the Bosch EDC16C37. Before flashing, the engineer identifies the exact revision and selects the write method.
Does Stage 1 void the warranty on the Chevrolet Silverado?
Stage 1 on the Chevrolet Silverado voids the factory warranty on the engine and transmission — this is standard for all manufacturers. CHIPOK provides its own warranty on the quality of the remap.
How quickly is chip tuning of the Chevrolet Silverado 6.6 Duramax 360 hp done?
The full remap cycle for the Chevrolet Silverado — from reading to writing the final file — takes 30-90 minutes depending on the ECU access method. The file is prepared at CHIPOK in 5-30 minutes.
Can you return to stock after Stage 1 on the Chevrolet Silverado?
The original Chevrolet Silverado ECU is always saved before flashing. Rolling back to the factory firmware is done with the same programmer in 25-30 minutes.
How much does Stage 1 cost for the Chevrolet Silverado 6.6 Duramax 360 hp?
The cost of Stage 1 for the Chevrolet Silverado 6.6 Duramax 360 hp is calculated in the calculator on this page — you select the options (DPF off, EGR off, AdBlue off, DTC off, etc.) and the price is capped by the package Max Price. Payment is by credits (1 cr = 1 €), with no subscriptions.