Chevrolet Corvette 6.2 V8 455 hp — Stage 1 file (+25 hp)
hp
Stage 1 file for Chevrolet Corvette 6.2 V8 455 hp
Target +0 hp. Custom development for your engine.
Chip tuning for Chevrolet Corvette 6.2 V8 455 hp ECU
Chevrolet Corvette (2013 - C7) 6.2 V8 455 hp — mass-market petrol engine of the passenger segment of the General Motors group (США, 1911). Stage 1 chip tuning raises power from 455 to 480 hp (+25 hp, +5%) and torque from 624 to 650 Nm (+26 Nm). This engine ships with different ECU variants: Delco E38, Delco E92, Delco T87. The flashing method is determined by the specific unit: OBD, Bench or Boot mode. In the CHIPOK database: 3 configurations · 3 ECU variants. A petrol engine built in 2013 — a Tricore platform without strong protection; OBD access works.
The Camaro and Corvette are Chevrolet's iconic muscle and sports cars. The Silverado is Chevrolet's flagship pickup. Chevrolet shares platforms with GMC, Cadillac and Buick within GM. The LT-series V8 is the modern LS replacement, fitted to Camaro/Corvette/Silverado. Chevrolet 2.0 / 1.4 Turbo are mainstream turbo engines for saloons and compacts. GM ECUs (E78/E80/E92) are Bosch-based but use their own checksum.
HP Tuners is the primary tool for Chevrolet/GM in the US. The US Chevrolet community is the largest for Camaro, Corvette and LS-swaps. Camaro/Corvette confidently reach Stage 2 with hardware. HP Tuners is the leading tool for top Chevrolet models. Top Chevrolet Corvette / Camaro ZL1 engines sit at the power ceiling of the American performance segment.
Frequently asked questions
What is the Stage 1 effect on the Chevrolet Corvette 6.2 V8 455 hp?
Stage 1 chip tuning on the Chevrolet Corvette 6.2 V8 455 hp boosts engine output by 25 hp: from 455 to 480 hp. Torque rises from 624 to 650 Nm (+26 Nm).
What changes in the Chevrolet Corvette ECU after Stage 1?
Stage 1 is a software optimization of the factory ECU firmware of the Chevrolet Corvette with no hardware changes. The injection, boost, ignition-timing and torque maps are reprogrammed. The gain is +25 hp with no hardware changes.
Does Stage 1 make sense on the Chevrolet Corvette 6.2 V8 455 hp with this much power?
On the top-spec Chevrolet Corvette 6.2 V8 455 hp engine, Stage 1 is the starting point before Stage 2 with a downpipe, intake and a larger intercooler. The mass-market factory calibration leaves substantial headroom for an aggressive software tune.
What is Stage 2 for the Chevrolet Corvette 6.2 V8 455 hp?
Stage 2 for the Chevrolet Corvette 6.2 V8 455 hp is Stage 1 plus hardware changes: a downpipe, a larger intake and a performance intercooler. The gain is considerably higher, but it requires professional component selection.
Which control units is the Chevrolet Corvette 6.2 V8 455 hp built with?
The Chevrolet Corvette 6.2 V8 455 hp comes with 3 ECU variants: Delco E38, Delco E92, Delco T87. Calibration is done for the specific unit after the revision is identified.
Does the factory warranty of the Chevrolet Corvette remain valid after Stage 1?
After remapping the Chevrolet Corvette, the official factory warranty on the engine and gearbox is lost (this applies to any manufacturer when the ECU is modified). CHIPOK guarantees the quality of the calibration and free revisions.
How long is the wait for a Stage 1 remap for the Chevrolet Corvette?
Reading and writing via OBD takes 25-30 minutes on the Chevrolet Corvette. Bench reading (BDM/JTAG) takes about 60 minutes plus refitting. Remote file processing at CHIPOK takes 5-30 minutes.
How do you roll back to the factory firmware of the Chevrolet Corvette?
Before Stage 1 the original of the Chevrolet Corvette 6.2 V8 455 hp is read out and saved — returning to the factory state is possible at any time.
How much does chip tuning the Chevrolet Corvette 6.2 V8 455 hp cost?
The remap price for the Chevrolet Corvette 6.2 V8 455 hp is dynamic and is calculated in the CHIPOK calculator based on the selected options. A credit-based payment model, with no subscription fees.