Chevrolet Captiva 2.4i 136 hp — Stage 1 file (+8 hp)
hp
Stage 1 file for Chevrolet Captiva 2.4i 136 hp
Target +0 hp. Custom development for your engine.
Chip tuning for Chevrolet Captiva 2.4i 136 hp ECU
Chevrolet Captiva (2006) 2.4i 136 hp — mass-market petrol engine of the passenger segment of the General Motors group (США, 1911). Stage 1 chip tuning raises power from 136 to 144 hp (+8 hp, +6%) and torque from 220 to 230 Nm (+10 Nm). ECU — Bosch ME7.9.9. Flashing method: OBD or Bench depending on the unit's protection. The 2006 generation — old-era petrol ECUs (ME7/ME9/MED9/Simos) with easily readable memory.
Chevrolet is an American carmaker, founded in 1911 and part of General Motors since 1918. Chevrolet is GM's mass-market brand, focused on pickups, muscle cars and SUVs. The LS-series V8 is Chevrolet's iconic engine family (Camaro, Corvette). The LT-series V8 is the modern LS replacement, fitted to Camaro/Corvette/Silverado. GM ECUs (E78/E80/E92) are Bosch-based but use their own checksum. The LS-series V8 is Chevrolet's iconic engine range dating from 1997.
LS-swap is an industry of its own (Chevy LS engines into any car). HP Tuners is the primary tool for Chevrolet/GM in the US. The US Chevrolet community is the largest for Camaro, Corvette and LS-swaps. Mid-range Chevrolet models are a mainstream chip tuning subject.
Frequently asked questions
What power gain do you get after chip tuning the Chevrolet Captiva 2.4i 136 hp?
The Stage 1 gain for the Chevrolet Captiva 2.4i 136 hp is 8 hp (+6%) over the stock 136 hp, for a total of 144 hp. Torque rises from 220 to 230 Nm (+10 Nm).
What is Stage 1 chip tuning for the Chevrolet Captiva?
Stage 1 is a software optimization of the factory ECU firmware of the Chevrolet Captiva with no hardware changes. The injection, boost, ignition-timing and torque maps are reprogrammed. The gain is +8 hp with no hardware changes.
What is the risk of Stage 1 on the Chevrolet Captiva 2.4i 136 hp?
A remap of the Chevrolet Captiva 2.4i 136 hp is safe — the factory calibration in this mid-range class is conservative, leaving genuine headroom for Stage 1 with no hardware changes.
What is Stage 2 for the Chevrolet Captiva 2.4i 136 hp?
Stage 2 on the Chevrolet Captiva 2.4i 136 hp means software + hardware (exhaust, intake, intercooler). The gain depends on the specific hardware combination.
What ECU platform does the Chevrolet Captiva 2.4i 136 hp use?
The Chevrolet Captiva 2.4i 136 hp is fitted with the Bosch ME7.9.9 ECU. The read method depends on the unit's protection: OBD, Bench via BDM, or Boot mode.
Does the factory warranty of the Chevrolet Captiva remain valid after Stage 1?
After remapping the Chevrolet Captiva, the official factory warranty on the engine and gearbox is lost (this applies to any manufacturer when the ECU is modified). CHIPOK guarantees the quality of the calibration and free revisions.
How long is the wait for a Stage 1 remap for the Chevrolet Captiva?
Reading and writing via OBD takes 25-30 minutes on the Chevrolet Captiva. Bench reading (BDM/JTAG) takes about 60 minutes plus refitting. Remote file processing at CHIPOK takes 5-30 minutes.
How do you roll back to the factory firmware of the Chevrolet Captiva?
Before Stage 1 the original of the Chevrolet Captiva 2.4i 136 hp is read out and saved — returning to the factory state is possible at any time.
How much does chip tuning the Chevrolet Captiva 2.4i 136 hp cost?
The remap price for the Chevrolet Captiva 2.4i 136 hp is dynamic and is calculated in the CHIPOK calculator based on the selected options. A credit-based payment model, with no subscription fees.