Audi SQ8 4.0 TFSI 507 hp — Stage 1 file (+93 hp)
hp
Stage 1 file for Audi SQ8 4.0 TFSI 507 hp
Target +0 hp. Custom development for your engine.
Chip tuning for Audi SQ8 4.0 TFSI 507 hp ECU
Audi SQ8 (2019) 4.0 TFSI 507 hp — premium petrol engine of the passenger segment of the Volkswagen Group (VAG) group (Германия, 1909). Stage 1 chip tuning raises power from 507 to 600 hp (+93 hp, +18%) and torque from 660 to 830 Nm (+170 Nm). This engine ships with different ECU variants: Bosch MED17.1.1, Bosch MG1CS008. The flashing method is determined by the specific unit: OBD, Bench or Boot mode. The ZF AL552 TCU is calibrated with a separate file — torque limiter and shift maps for Stage 1. In the CHIPOK database: 3 configurations · 3 ECU variants. A modern petrol engine built in 2019 — a generation with encrypted ECU protection (Tricore TPROT); top engines require Bench.
Audi shares platforms with Volkswagen, Porsche, Bentley and Lamborghini within VAG. Audi's signature slogan is “Vorsprung durch Technik” (Progress through Technology). Audi is a premium manufacturer from Ingolstadt (Bavaria), founded in 1909 as Audiwerke August Horch & Cie. Audi RS models are the top of the Audi Sport range and direct rivals to Mercedes-AMG and BMW M. The factory calibration of Audi petrol engines is conservative, leaving headroom for Stage 1. TFSI is Audi's signature designation for direct-injection petrol turbo engines.
APR and Revo are the leading tuning brands for Audi, right up to Stage 1+. On Audi, Stage 1 usually fits within the standard turnaround time. Protection on modern Audi RS models is the tightest in the group, so Bench is required. A Bench read is standard procedure on modern RS engines. RS engines are a proven base once supporting hardware is added (downpipe, intake and intercooler). Top-tier Audi Sport engines (RS models) sit at Audi's power ceiling; the gain is significant. APR and Revo are the leading tuning brands for top Audi engines.
Tiptronic is Audi's classic automatic for longitudinally mounted engines. S tronic comes in dry and wet-clutch versions, each with a different torque rating. S tronic is Audi's signature dual-clutch gearbox (the DSG in the Audi range).
Frequently asked questions
What power gain do you get after chip tuning the Audi SQ8 4.0 TFSI 507 hp?
The Stage 1 gain for the Audi SQ8 4.0 TFSI 507 hp is 93 hp (+18%) over the stock 507 hp, for a total of 600 hp. Torque rises from 660 to 830 Nm (+170 Nm).
What is Stage 1 chip tuning for the Audi SQ8?
Stage 1 is a software optimization of the factory ECU firmware of the Audi SQ8 with no hardware changes. The injection, boost, ignition-timing and torque maps are reprogrammed. The gain is +93 hp with no hardware changes.
Does Stage 1 make sense on the Audi SQ8 4.0 TFSI 507 hp with this much power?
Stage 1 for the Audi SQ8 4.0 TFSI 507 hp unlocks the potential built in by the factory but artificially capped to meet mass-market targets. A base of 750-800 hp is achievable once hardware is added.
What is Stage 2 for the Audi SQ8 4.0 TFSI 507 hp?
Stage 2 on the Audi SQ8 4.0 TFSI 507 hp means software + hardware (exhaust, intake, intercooler). The gain depends on the specific hardware combination.
Which control units is the Audi SQ8 4.0 TFSI 507 hp built with?
The Audi SQ8 4.0 TFSI 507 hp comes with 2 ECU variants: Bosch MED17.1.1, Bosch MG1CS008. Calibration is done for the specific unit after the revision is identified.
What does remapping the ZF AL552 gearbox give on the Audi SQ8 4.0 TFSI 507 hp?
The ZF AL552 TCU is calibrated separately: the torque limit is raised, the shift maps are optimized for the Stage 1 characteristics, and launch control is re-tuned. The TCU file is flashed separately from the ECU.
Does the factory warranty of the Audi SQ8 remain valid after Stage 1?
After remapping the Audi SQ8, the official factory warranty on the engine and gearbox is lost (this applies to any manufacturer when the ECU is modified). CHIPOK guarantees the quality of the calibration and free revisions.
How long is the wait for a Stage 1 remap for the Audi SQ8?
Reading and writing via OBD takes 25-30 minutes on the Audi SQ8. Bench reading (BDM/JTAG) takes about 60 minutes plus refitting. Remote file processing at CHIPOK takes 5-30 minutes.
How do you roll back to the factory firmware of the Audi SQ8?
Before Stage 1 the original of the Audi SQ8 4.0 TFSI 507 hp is read out and saved — returning to the factory state is possible at any time.
How much does chip tuning the Audi SQ8 4.0 TFSI 507 hp cost?
The remap price for the Audi SQ8 4.0 TFSI 507 hp is dynamic and is calculated in the CHIPOK calculator based on the selected options. A credit-based payment model, with no subscription fees.